Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
engineer-mechanical:solidworks [2018/05/17 15:57]
jjensen [Title Block Requirements]
engineer-mechanical:solidworks [2018/05/17 17:21] (current)
jjensen [Title Block Requirements]
Line 299: Line 299:
   * Scale and Sheet Size   * Scale and Sheet Size
   * Units   * Units
 +    * "​UNLESS OTHERWISE SPECIFIED, ALL DIMENSIONS ARE IN INCHES (IN)"
 +    * "​UNLESS OTHERWISE SPECIFIED, ALL DIMENSIONS ARE IN MILLIMETERS (mm)"
 +      * (ASME-Y14.100-2004 Engineering Drawing Practices, p. 8)
 +    * 0.9 mm (don't use .9 for millimeters)
 +    * .9 IN (don't use 0.9 for inches)
 +      * "A zero is not used before the decimal point for values less than 1 in"
     * Tolerances     * Tolerances
   * Material   * Material
Navigation

Civil Engineering Engineering - Computer Engineering - Electrical Mechanical Engineering

Print/export
QR Code
QR Code engineer-mechanical:solidworks (generated for current page)