Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
engineer-mechanical:inventor-isosketchadvance [2018/03/23 20:41]
jjensen [Isometric Sketches - Advanced Planes 1 of 10]
engineer-mechanical:inventor-isosketchadvance [2018/03/23 20:50]
jjensen [Isometric Sketches - Advanced Planes 1 of 10]
Line 33: Line 33:
   * create a rectangle position at the origin   * create a rectangle position at the origin
   * Smart Dimension width 1.75 and height 2.5 inches   * Smart Dimension width 1.75 and height 2.5 inches
-  * close the sketch+  * finish ​the sketch
   * Extrude the feature 1.25 inches thick   * Extrude the feature 1.25 inches thick
 +  * New sketch on front XY face
 +  * line -> construction
 +  * dimension 0.75
 +  * Constrain -> Coincident Constraint
 +  * now sketch should be Fully Constrained
 +  * On the Ribbon -> 3D Model tab -> Plane -> Three Points
 +  * New sketch on compound angle workplane
 +  * Project Geometry -> Project Cut Edges
 +  * Finish sketch
 +  * Extrude with cut option
 +  * turn off visibility of workplane
 +  * turn off visibility of sketch
 +  * And successfully created a part using a plane at a compound angle
 +  * Thank you for watching
 ==== Descriptive Geometry Problem 8-15 ==== ==== Descriptive Geometry Problem 8-15 ====
   * {{engineer-mechanical/​inventor-isosketchadvance:​technicaldrawing4th-goetsch-prob08-15-p323.png|Figure 1-1 Descriptive Geometry Problem 8-15}}   * {{engineer-mechanical/​inventor-isosketchadvance:​technicaldrawing4th-goetsch-prob08-15-p323.png|Figure 1-1 Descriptive Geometry Problem 8-15}}
Navigation

Civil Engineering Engineering - Computer Engineering - Electrical Mechanical Engineering

Print/export
QR Code
QR Code engineer-mechanical:inventor-isosketchadvance (generated for current page)