Project: Geneva Wheel

Geneva Wheel - Part 1
  • Create the Geneva wheel using the dimensions from Figure 1-0. Recommend creating a wedge of the geneva wheel (see Figure 3-0) then use the Pattern - MIRROR to create the opposite end. Then use Pattern - CIRCULAR array to duplicate the feature 6 times to complete the geneva wheel. Add the boss and keyway to complete the geneva wheel.
  • Figure 1-0 Geneva Wheel 2D Sketch
  • Figure 3-0 Geneva Wheel 2D Sketch
  • Figure 4-0 Geneva Wheel Multiview and Isometric
  • Geneva-Wheel Keyway, 0.36“ wide and 0.20” height. Position the center of the rectangle 0.825“ from the center of the geneva-wheel.
    • Figure 2-0 Geneva Wheel Keyway
    • Figure 3-0 Procedure to Create a Geneva Wheel - Animation
Geneva-Driver - Part 2
Geneva-Base - Part 3
Geneva-Pin - Part 4
Geneva Assembly - Part 5
Geneva Presentation - Part 6
References
Navigation

Civil Engineering Engineering - Computer Engineering - Electrical Mechanical Engineering

Print/export
QR Code
QR Code engineer-mechanical:inventor-genevawheel (generated for current page)