Differences

This shows you the differences between two versions of the page.

Link to this comparison view

engineer-mechanical:csi:slide-fit [2019/04/04 09:22]
jjensen created
engineer-mechanical:csi:slide-fit [2019/04/04 09:27] (current)
jjensen
Line 8: Line 8:
   * American National Standard ANSI B4.1-1967 (R1987) Class RC2   * American National Standard ANSI B4.1-1967 (R1987) Class RC2
     * RC 2 //Sliding fits// are intended for accurate location, but with greater maximum clearance than class RC 1. Parts made to this fit move and turn easily but are not intended to run freely, and in the larger sizes may seize with small temperature changes. (Shop Reference for Students and Apprentices, 2nd p. 211)     * RC 2 //Sliding fits// are intended for accurate location, but with greater maximum clearance than class RC 1. Parts made to this fit move and turn easily but are not intended to run freely, and in the larger sizes may seize with small temperature changes. (Shop Reference for Students and Apprentices, 2nd p. 211)
 +
 +==== Equipment ====
 +  * Dial bore gauge
 +    * [[https://www.shars.com/products/measuring/bore-gages|Shars Dial Bore Gauge]]
 +
 +==== Schedule ====
 +  * cut 4" length male
 +  * cut 3" length female, 1.75" diameter
 +  * drill
 +  * bore
 +    * check carbide bit is in line with live center
 +  * face
 +  * turn outer diameter
 +  * flip
 +  * saw off
 +  * face
 +  * clean and deburr
Navigation

Civil Engineering Engineering - Computer Engineering - Electrical Mechanical Engineering

Print/export
QR Code
QR Code engineer-mechanical:csi:slide-fit (generated for current page)